#Realtimes trimmer not working manual#
#Realtimes trimmer not working full#

To clean the electrodes of the candle from combustion products, you can use a fine-grained 'sandpaper'.Usually this contributes to the disappearance of traces and reduce the amount of soot. If with this recipe oil leaks appear on the motor, and a strong deposit forms on the candle, halve the proportion of oil. There is one trifle: the recommended ratio is 1: 25 (for all brands of oil) or 1: 50 (for “native” oils). If your unit does not need pure gasoline, but a mixture of it with engine oil, strictly observe the proportions indicated in the operating instructions.Then you can choose a more suitable one instead. If you are unable to tighten / loosen the adjusting screws normally, it may be because the spring is too thick and stiff.During the operation of the lawn mowers, you most likely will have to bother with it more than once, because an unbalanced carburetor means both increased fuel consumption and quick failure of candles, not to mention a decrease in the power and performance of the device. Remember that carb adjustment is not the final procedure. See also Husqvarna chainsaw does not start well when cold If the engine starts poorly, tighten the screw a little. At the same time, make sure that the motor makes several dozen revolutions before the movement of knives / reel with fishing line. For a better start, speed up the engine a little.

The screw must be adjusted so as to ensure reliable motor operation at low speeds. By weakening it, you reduce the number of revolutions, twisting – increase. The second screw, as mentioned above, controls the engine idle speed.

#Realtimes trimmer not working full#

Next, you should slowly unscrew the screw (each turn is the same 45 degrees) until the moment when at full throttle the motor begins to firmly produce a maximum of revolutions. Open the throttle and see how the speed increases. If you do not have time and the motor stalls, you should turn the screw 90 degrees. Catch the moment when the motor starts to stall, and turn the screw in the opposite direction by 45 degrees. Slowly tighten the first adjusting screw (fuel mixture supply).

Next, turn on the unit and wait for the engine to warm up. Usually there are three of them: the first is responsible for supplying fuel, the second for idling, well, and the third is designed to limit the number of maximum engine speeds.

#Realtimes trimmer not working manual#

It is easiest to rinse it (it is advisable to flush the filter with water regularly after 9-10 hours of operation).Īfter that, in the scheme of your trimmer, which is in the instruction manual of the device, find the adjustment screws. To correctly adjust the carburetor lawn mowers, you must follow a certain procedure.